08234TFP38_TDS.pdf

5700 Skylab Road Phone: +1 714-899-8100 E-mail: airtech@airtech.com
iT Huntington Beach Fax: + 1 714-899-8179 Website: www.airtech.com
fF = CA 92647 USA
INTERNATIONAL INC.
Data Sheet RELEASE EASE 234 TFP, 234 TFP-HP & 234 TFP-1
Porous PTFE coated fibreglass fabrics
lM DESCRIPTION
Release Ease 234 TFP is a porous PTFE coated glass fabric which will provide release from all conventional resin
systems. Porous products will allow excess resin, volatiles and trapped air to escape into the breather during cure
while non-porous products will retain resin. Release Ease products have a continuous service temperature to 288 C
(550 F).
Release Ease 234 TFP-HP has reduced PTFE content for increased porosity.
Release Ease 234 TFP-1 has reduced thickness of 40 tm (0.0016 inch).
@ BENEFITS
+ Porous PTFE coating makes fabric much easier to remove off of cured laminates, resulting in time saved.
+ Release Ease strips off cured laminates leaving a textured surface, reducing time spent hand finishing.
+ Fibreglass retains its strength through high temperature use for easier removal after cure.
M@ TECHNICAL DATA
Release Ease 234 TFP Release Ease 234 TFP-HP _ Release Ease 234 TFP-1
Maximum use temperature 288 C (550 F) 288 C (550 F) 288 C (550 F)
Fibre type Fibreglass Fibreglass Fibreglass
Coating type PTFE PTFE PTFE
Thickness 0.060 mm (0.0024 inch) 0.076 mm (0.003 inch) 0.040 mm (0.0016 inch)
Colour Brown Brown Brown
Cromael Recommended storage temperature is 5 C to 40 C (41 F to 104 F).
9 Store indoors in original packaging, do not stack rolls on end.
M@ SIZES
pith bength | Packaging
Release Ease 234 TFP 97 cm (38 inches) 91 m (100 yards) Troll
127 cm (50 inches) 91 m (100 yards) Troll
152 cm (60 inches) 91 m (100 yards) Troll
Release Ease 234 TFP-HP. 97 cm (38 inches) 91 m (100 yards) Troll
Release Ease 234 TFP-1 97 cm (38 inches) 91 m (100 yards) Troll
SUSTAINABILITY
&
SPE Recyclable
DSH packaging
wy
@ NOTES
+ The maximum use temperature is dependent upon the duration at maximum temperature and is process
specific, Airtech recommends testing prior to use.
+ Colour is subject to slight variation and does not affect performance.
+ Hot knife (sealed edge) slitting upon request with 1 roll minimum order quantity.
Last updated : 2025-05-18
Catalog position : Release fabrics & Peel plies
ste contin creo ue nding sarge beyond ot conta itech trator does ese pony for the peromnance fhe for ry parr. The mates sols Artech intetonl n