SHD COMPOSITE MATERIALS INC www.shdcomposites.com a = a
203 McKenzie Road Ss H BD)
Mooresville Tel +1 (704) 6266876 composites
Nc 28117 advanced composite
sales@shdcomposites.com materials
Epoxy Adhesive Film
Introduction
VTFA400 (DF034) toughened epoxy adhesive film is design to cure between 150 F and 250 F, allowing
flexibility in component manufacture.
Typical applications: General purpose
Key Features & Benefits
e Cure temperature from 150 F to 265 F
e Service temperature up to 260 F after post cure
e Low CTE and shrinkage
Work life at 70 F: 21 days
e Storage life at O F: 12 months
e Very low VOC content no added solvents during manufacture
Storage & Out Life
This material should be kept frozen at O F. It must be kept sealed in a polythene bag which must not be
opened until fully thawed to room temperature. If the material is not fully used, then the material must be
resealed in the polythene bag to prevent moisture absorption.
Issued 01* February 2018
Note: The information and assistance provided herein is for your consideration without legal responsibility. Users are required to perform verification and
testing to confirm that the product meets with their requirements.